編程單個SB8F

在對傳感器盒進行編程之前，請確保有線輸入處于所需配置（開/關）以啟用輸出。按下AUTOSET按鈕并按住3秒鐘，直到READING紅燈開始閃爍，然后松開。紅燈（READING）閃爍表示微處理器正在讀取和存儲全部輸入的狀態。然后紅燈熄滅，啟用了輸出。黃燈（STORED）指示啟用輸出。

Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for 3 seconds until the READING red light starts fashing, then release it.The red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).

配置和指標

?S1：實現選擇輸出信號的類型，PNP（P/2）或NPN（N）。

?S2：分別根據NPN或PNP選擇（通過S1）實現選擇內部PULLUP（PU）或PULL-DOWN（PD）電阻器。

?L1：通電時為綠色。

?L2：當常閉系列輸出切換時為琥珀色（例如：全部觸點打開）。

?L3：當切換常開系列時琥珀色（例如：全部觸點閉合）。

?S1: enables the selection of the type of output signal, PNP(P/2) or NPN (N).

?S2: enables the selection of internal PULL-UP (PU) or PULLDOWN(PD) resistors depending on the NPN or PNP selection(via S1), respectively.

?L1: green when powered.

?L2: amber when the NC series output is switched (e.g. allcontacts open).

?L3: amber when the NO series is switched (e.g. all contactsclosed).

雙鉗口自動校準平行i氣動夾具(SGP-S系列)

?雙動作。

?反沖調整系統。

?小尺寸高i性能。

?緊固的構造使其非常適合重型作業的運用，使用壽命長，免維護。

?不同的緊固和輸送選項。

?隨時用于 PRO-SN…HS (1) 可編程磁性傳感器。

?食物級潤滑油FDA-H1。

Double acting.? Backlash adjusting system.? High performance in small dimensions.? The rugged construction lends itself to heavy duty applicationsfor a trouble free long life without maintenance.

Various fastening and air feeding options.? Ready for PRO-SN …HS (1) programmable magnetic sensor.? Food grade grease FDA-H1.